Eazypod Auto Box Screws

Reviews

Write Your Own Review

FAQ (37)

Customer Questions

How do I replace the waste ball valve on my EazyPod

If you have one of the Mk1 EazyPods with a ball valve, you will need to buy a Single Union Ball Valve and a EazyPod Tank Connector.

Can an old EazyPod be adapted to take smaller K1 Micro?

Yes, 18 litres of K1 Micro can be used. No adaptations are necessary. K1 Micro offers increased surface area and may provide clearer water.

Can EazyPod be upgraded to automatic cleaning?

No, the EazyPod Automatic is configured differently and would have to be purchased separately.

Is EazyPod a complete filtration system? Will I need anything else?

EazyPod is a complete mechanical and biological filter, trapping debris and breaking down biological waste from fish. A basic EazyPod on its own is not supplied with a pump (to pump water to it from the pond,) or an airpump, to clean it. You’ll also ...

What is EazyPod Automatic?

EazyPod Automatic is an EazyPod which can automatically clean its own media. Available with or without UVC, EazyPod Automatic has a control box which can be set by the user to clean itself on a timer, as little or as often as they require. EazyPod Automatic...

Can EazyPod be run gravity-fed?

The EazyPod and EazyPod Air can be converted to gravity feed, there are instructions on how to do this in the EazyPod manual which can be downloaded here. The EazyPod Complete and Automatic EazyPods cannot be gravity fed.

Can EazyPod Automatic be gravity-fed?

No, it’s not possible to run EazyPod Automatic as a gravity fed filter. The Nexus 220 and 320 can be gravity fed with the addition of the Automatic upgrade

Media is escaping and being discharge to waste when cleaning my Eazypod

This can happen if the outer steel mesh is slightly out of position, this sometimes happens during transit, remove all of the media from the biological chamber (this will stop any media becoming trapped when you tap the mesh back into place), with a ...

I want to recess the EazyPod away from the pond. How do I do that?

EazyPod comes with a rubber connector which allows 4” rigid pipe to be fitted. Place the EazyPod where you want it away from the pond (the base of a pump-fed EazyPod must always be above surface of pond level, gravity fed installations the EazyPod should...

What size pump do I need for an EazyPod?

EazyPods are suitable for ponds up 10,000 litres, and we recommend that a pond is turned over once every two hours. A 5000lph pump (like a Bermuda Filter Force 5000,) would be perfect.

How can I extend the cleaning cycle from 6 minutes to up to 10 minutes on my Eazypod Auto?

You first need to remove cycle timer sticker and then increase the dial from 60 to 100 so that the cycle time would increase to 10 minutes from the original 6 minutes.

What are the air stones used for that come with an EazyPod Air / EazyPod Complete?

The air stones need to sit at the bottom of the pond to provide extra aeration. You use the supplied manifold to divert the air from the air pump, so air can be used to clean the EazyPod and also to aerate the pond via the air stones. This illustration...

What volume of water is send to waste in my Eazypod during a cleaning cycle?

Approx 80L of water is send to waste during each cleaning cycle.Please see the manual for more information.

I want to install the EazyPod on a gravity fed system, what height will the water level be?

The measurement on gravity fed Eazypods will be 555mm from the floor to the water level inside the EazyPod. Remember to remove the black inlet pipe and make the necessary changes to the filter as shown in the instructions, as the EazyPod will arrive ...

My K1 Micro stays on the surface of the water in my Eazypod and will not sink

The K1 Micro when brand new is buoyant and will want to float on the surface of the water. This is perfectly normal. As soon as fish have been added to the pond it takes the K1 Micro approximately 24 to 48 hours to absorb the water and become semibuoyant...

The K1 Micro doesn’t move well during the cleaning cycle

The air pump is either not powerful enough or there isn’t enough water in the EazyPod. Check all air fittings and line for leaks. Make sure you haven’t inadvertently added more K1 Micro than the 18 Litres.

The pond gets dirty after cleaning my Eazypod

Check that you have turned your circulating pump off, so that the dirt in the K1 Micro hasn’t returned to the pond.If the K1 Micro appears to bubble (boil) above the outlet water level during cleaning, some dirt may return back to the pond. This is not...

Too much maintenance, poor clarity, or EazyPod overflowing

Make sure that you haven’t exceeded the maximum flow rate. Please ensure that the EazyPod has gone through a minimum of 2 to 3 cleaning cycles.

There is no power to my Eazypod automatic control box.

Check the wiring is correctly installed. Seek advice from a suitably qualified electrician if in doubt. Check the mains connection to the control box. Seek advice from a suitably qualified electrician if in doubt. Check the fuse inside the control...

EazyPod Automatic does not drain to waste

Check that the 1” ball valve on the EazyPod Automatic is in an open position. (You can check this by removing the union end from the waste valve) Is cleaning cycle fully operational. From initiating a cleaning cycle it will take 3 to 4 minutes before...

EazyPod Automatic does not close waste valve

You will find out that the circulation pump will not switch on and the green and amber light are both illuminated. Remove the unions from the waste valve and check for any blockages. Check the fuse inside the control box. This is located in the hinged...

Can you retro fit an Eazypod?

No, it is not possible to retrofit an Eazypod. You can however retrofit a Nexus.

Does the UV need to be switched off on my Eazypod during the cleaning cycle?

The UV stays on throughout the process and no harm comes to the UV or the unit.

Why is the media in my Eazypod sitting high up and water is flowing down the overflow channels?

This problem occurs when the media is very blocked and the water can’t flow through it easily. The filter needs to be cleaned, preferably at least twice to flush the dirt out. This problem may occur if the filter hasn’t been cleaned for a while or a...

How can I extend the draining time of my Eazypod Automatic?

To extend the time that the waste valve is open you can change the setting on one of dials on the timers inside the auto box. The bottom dial on the right hand timer is set at 30%, if you change that dial to 20% or 10% the waste valve will open sooner...

How often will the filter need cleaning?

Typically in summer the filter will require cleaning once or twice a week, however every pond if different and cleaning requirement will vary depending on stocking density, exposure to sun and other variables.

Why do I need to clean my filter more often?

Too much algae. Excessive water flow and pressure. Check pump size. Overloaded with fish. Excessive feeding. Filter blocked through calcium.

Who are Kessil?

Kessil is a brand name of Di-Con – an American company which specialises in design and manufacture of LED lights for everything from photography and filming, to aquariums and horticulture.

Which Kessil light do I need for my reef tank?

As a general rule, 1 x A160WE Tuna Blue lights 45x45x45cm and 1 x A360WE Tuna Blue lights 60x60x60cm. 1 x A360X lights up to 90x60x60cm or 75x75x75cm, and an A360 Narrow lights 45x45x75cm. An AP700 lights up to 120x60x60cm, and the A80 Tuna Blue lights...

Can I control Kessil Lights straight out of the box, or do I need an extra controller?

All Kessil lights can be controlled on the top of the lamp with a knob which controls brightness, and another which controls spectrum. The AP700 has touch capacitive buttons. In order to have the lights come on at timed intervals they will require a ...

Are Kessil Lights passive or active cooled?

The small A80 is passively cooled with a built-in heat sink, but all other lamps are actively cooled with built in fans. This enables a very high output of light from a small area.

What is the warranty on Kessil Lights?

All Kessil products are guaranteed for one year from the date of purchase. Kessil lamps or controllers are not waterproof, so if dropped in water or splashed, causing damage, units are inspected and claims not entertained.

How do I mount Kessil Lights on my tank?

Kessil is famous in the aquatics industry for its gooseneck mounts. These are bendy, flexible mounting arms which can clamp to a tank rim in a number of ways, and then the light pointed to where it’s needed. For those who crave a neater solution, the...

Are there any upgrades or add-ons for Kessil Lights?

The A360X has a Narrow Reflector (launched March 2019,) which will focus the beam, and a Wi-Fi dongle and diffusor lens are also expected for the future. All will be available separately.

Is The Complete Liquid Plant Food safe for invertebrates?

Yes, it is safe to use with all invertebrates including snails and freshwater shrimp

How often should I use Complete Liquid Plant Food?

Directions are to dose daily, however weekly dosing calculations can be made, and still have great results with plants.

Will I benefit from using other fertilizers?

The Aquascaper plant food is classed as Complete, so includes macro and micro nutrients, and NPK. Dosage can be further increased for demanding situations. If individual dosing of elements is required instead, Evolution Aqua also distribute Aquaforest...

Did you find what you were looking for?

Your question:

Your name:

get notification on email when the answer is ready

Your e-mail:

Cookie Notice!

Eazypod Auto Box Screws

Reviews

FAQ (37)