Varipumps | Evolution Aqua

High performance controllable pond pumps

Varipump by Evolution Aqua is a controllable pond pump, suitable for large ponds. Output and energy consumption can be controlled at the push of a button allowing you to set the flow rate to your needs, whilst monitoring the wattage that the pump is running at. The motor is quiet and reliable, delivering consistent performance.

Available in three sizes, 10,000lph, 20,000lph and 30,000lph, Varipump is powerful enough to run the largest of ponds and filters, and in the most demanding of situations. It can be used as a submersible pond pump or it can be installed out of the pond, drawing water from the pond and through your filtration system.

Hosetail fittings are included.

Varipump FAQs

Can the Varipump be used with Nexus and EazyPod automatics?

Yes, the Varipump is ideal for using with either the Nexus or EazyPod automatic.

Does the Varipump come supplied with a plug?

No, Varipump adheres to UK pond equipment laws, and requires that it is wired into a safe, compliant, outdoor electrical system, ideally with an RCD cut-off. If you are unsure, consult a qualified electrician.

What size fuse do I need for a Varipump?

As all the Varipumps use less than 700watts so 3 amp fuse is suitable.

How long is the power cable on a Varipump?

The cable from the mains to the control box is 2metres, the cable from the control box to the pump is 10metres, this makes the total length 12metres.

Can the Varipump control box be kept outside?

The control box is weather/rain proof and can be kept outside, it MUST NOT be submerged in water.

Can the Varipump be used as a dry pump?

Yes, the Varipump is suitable to use as a dry pump on a gravity fed system, the pump is not self-priming so a non-return valve needs to be used if the water level is below the pump.

If I am using rigid pipework what fittings are required the plumb the Varipump in?

You will need two unions to plumb the Varipump to rigid pipework, the Varipump 10000 takes 1½" threaded fittings and the 20000 and 30000 both require 2". Buy the ...

How do I clean the Varipump?

To clean the Varipump, follow the steps below or watch our YouTube video here: Step 1: Hold pump by the handle and remove the inlet strainer basket Step 2: Using a Phillips screwdriver, undo the four screws at the base of the pump body Step 3: Remove the volute Step 4: Clean any debris and algae...

My Varipump has no flow?

Check the pump is wired correctly, the fuse has not blown and the pump his switched on at the controller. If using the pump dry, make sure it is primed Ensure any valves in the pipework are open If using a non-return valve verify the orientation is correct Clean out leaves from basket strainer...

Why is my Varipump noisy?

Verify airtight plumbing on the suction plumbing especially fittings! Clean out leaves or other debris from basket strainer (if applicable). Increase pipe size where possible. Decrease suction pipe length, reduce the number of elbows, etc Verify hydraulic compatibility: i.e. pump and pipe are ...

How long is the Varipump guarantee?

This product is guaranteed against defects in material and workmanship for two years from the date of purchase, under normal usage. The guarantee DOES NOT APPLY in case of improper use, negligence, lack of maintenance or accidental damage to the pump. If the pump fails due to a manufacturing fault within...

A fault code is displayed on the Varipump controller

The controller can display a fault code if the pump develops a problem. Download the fault code troubleshooting guide at the bottom of this page to identify the issue. If your Varipump was manufactured before 2021, the fault codes are:E01 = Pump is out of water ...

Are Varipumps self-priming?

No it is not self-priming. It will need to be placed below the water level.

What fittings do I need to connect the Varipump to pressure pipe?

To attach 2” pipework to the Varipump 20,000 and 30,000, you would need to use a 2” single union, threaded female to plain female, EA code: K82-76-66.You can then glue 2” pressure pipe directly into this. With the 10,000 you would need to use the 11/2” version,EA code: ...

Read More

My Varipump has a plug, can I cut the plug off?

You may find that your Varipump has a two pin plug - cutting the plug will not void your guarantee.

The plug can be cut off and wired into a safe, compliant, outdoor electrical system, with an RCD cut-off. If you are unsure, consult a qualified electrician

Read More

What fittings do I need to reduce the Varipump from 2" to 1.5" Pressure Pipe?

For a 20,000 and 30,000 Varipump you will need to connect a 2” single union, threaded female to plain female Ea code: K82-76-66. You will then need a Plain Reducing Bush-2" to 1.5" Ea Code: ...

Read More

Should I store my varipump in winter?

If there is a chance that the water will freeze over and restrict the flow, then you should take it out of the pond and dry it out. Store it over winter in a dry place, then reconnect the pump again in spring.

Read More

How often will I need to clean my Varipump?

The Varipump should be cleaned regularly, depending on the pond – every pond is different. Check the pump monthly, and clean off any build up, and check that there is no debris in the impellor. 1-2 time per year, open up the pump and pull out the impellor and give everything a clean inside...

Read More

How do I calculate the head height?

To find the head height, measure the vertical distance from the surface of the water to the top of the waterfall. Remember to add 1 foot of head for every 10 feet of pipe that will connect the pump and waterfall.

Read More

How do I setup a Varipump 10,000 for Flexible Hose?

How to setup a Varipump 10,000 for Flexible Hose

Read More

How do I setup a Varipump 20,000 (or 30,000) for Flexible Hose?

How to setup a Varipump 20,000 (or 30,000) for Flexible Hose

Read More

How do I reduce a Varipump 20,000 and 30,000 from 2" to 1.5"?

How to reduce a Varipump 20,000 and 30,000 from 2" to 1.5"

Read More

How do I setup a Varipump 10,000 for Pressure Pipe using Single Unions?

How to setup a Varipump 10,000 for Pressure Pipe using Single Unions

Read More

How do I setup a Varipump 20,000 (or 30,000) for Pressure Pipe using Single Unions?

How to setup a Varipump 20,000 (or 30,000) for Pressure Pipe using Single Unions

Read More

MODEL	INLET	OUTLET	MAX FLOW (lph)	MAX FLOW. (gph)	MAX FLOW. (US gph)	MAX. HEAD	MAX. WATTS
Varipump 10000	1½"	1½"	10,000	2,200	2,642	5.5m	90W
Varipump 20000	2"	2"	20,000	4,400	5,283	6.5m	190W
Varipump 30000	2"	2"	30,000	6,600	7,925	6.5m	290W

MODEL	DIMENSIONS	CABLE LENGTHS
Varipump 10000	267mm (L) x 122mm (W) x 162mm (H)	2 metre cable from plug to control box 10 metre cable from pump to control box
Varipump 20000	319mm (L) x 142mm (W) x 181mm (H)
Varipump 30000	370mm (L) x 155mm (W) x 205mm (H)

High performance controllable pond pumps

Specifications

Useful Information

Dimensions

Pump Curves

Frequently asked questions

CONTACT INFO

Subscribe Newsletter

Help

Support

Cookie Policy

High performance controllable pond pumps

Specifications

Useful Information

Dimensions

Pump Curves

Frequently asked questions

Subscribe Newsletter

Help

Support