Replacement centre foam for old Nexus

Write Your Own Review

Customer Questions

How does the Nexus Automatic Air Control Valve Box work?

This video will show you how the Nexus Automatic Air Control Valve Box works. This will help you to troubleshoot any issues you may have encountered along side our other troubleshooting videos for the Nexus Automatic Control Box.

My Nexus is not draining to waste when valve is opened.

Remove the outside union on the waste ball valve, open the valve, if no water pours out the blockage is under the Nexus, carefully push a suitable stick (such as a cane) and release the blockage, you can also remove the Eazy and access the pipe from ...

How often do I need to change the media in my Nexus?

You should never need to change the media in your filter. You can add more to the outer chamber of your filter if required. Please see question 4 for more information before adding more.

Can Nexus+ be gravity or pump fed?

Yes, it can easily be adapted to either filtration method by simply swapping the supplied rubber boots.

Do I need an airpump for NexusPlus?

Yes, it powers the moving bed biological filter and is also vital to the cleaning process. You need an Evolution Aqua Air Pump 75 for a Nexus 220 and an Air Pump 95 for a Nexus 320. If you increase the amount of media in the outer chamber you may well...

How does the Nexus Automatic Waste Valve Relay work?

This video will show you how the Nexus Automatic Waste Valve Relay works. This will help you to troubleshoot any issues you may have encountered along side our other troubleshooting videos for the Nexus Automatic Control Box.

The K1 Micro in the Nexus Eazy doesn’t move well during the cleaning cycle

The reasons for this could be one of the following: The air pump is not powerful enough (see Air Pump Recommendation on page 4) There isn’t enough water in the Nexus – check that you used the cleaning pipe to maintain the level on a pump fed system...

How does the Nexus Automatic Control Box work?

Understanding the Nexus Automatic Control Box Video This video will show you how the Nexus Automatic Control Box works. This will help you to troubleshoot any issues you may have encountered along side our other troubleshooting videos for the Nexus ...

How does the Nexus Automatic Inlet Plate Relay work?

This video will show you how the Nexus Automatic Inlet Plate Relays work. This will help you to troubleshoot any issues you may have encountered along side our other troubleshooting videos for the Nexus Automatic Control Box.

K1 Micro is floating but K+Media is not in my Nexus, why is this?

The K+Media in normal conditions becomes semi-buoyant within 48 hours. However, the K1 Micro (only in the Eazy) takes longer to absorb water. This can take up to one week.

My Nexus is blocked with media/debris between the eazy and the main chamber

To clear the block you will need to drain down the outer chamber and clear the kiss points with a small flat screwdriver.

You will then need to refill the filter, the media should float up so it can remove by hand.

Can I retrofit a Nexus

It is possible to retrofit a Nexus. However this cannot be done for an Eazypod.

I have an Ammonia and / or Nitrite reading.

A typical filter can take approximately 8 weeks to mature. During this time Ammonia and Nitrite levels will rise and fall. This process can be accelerated by using PUREPOND. If you still experience Ammonia and Nitrite readings after this period of time...

I am using a Nexus, my pond has been running for longer than 2 months and my water is cloudy, why?

It is important that the Eazy is flushed a minimum of 2 times during cleaning. This ensures that all the debris collected is flushed out to waste. If the unit is only cleaned once some debris can be returned to the pond, clouding the water. Flush the...

How much water is drained to waste from my Nexus during a cleaning cycle?

In a Nexus 220+ 140 litres of water is drained to waste. In a Nexus 320+ just under 200 litres of water is drained to waste.

How can I extend the draining time of my Nexus Automatic?

You first need to remove the sticker of the far right side box and change the last dial with a small screwdriver from 50% to 40%, this will extend the cleaning time by one minute.

There is no power to the Nexus control box.

Check the wiring is correctly installed. Seek advice from a suitably qualified electrician if in doubt. Check the mains connection to the control box. Seek advice from a suitably qualified electrician if in doubt. Check the fuses inside the control...

How can I locate the fuse in the Nexus control box?

These are located alongside the timer blocks within their own hinged compartments. The fuses are all standard glass fuses; 10 Amp, 5 Amp, 2 Amp, 2 Amp from left to right.

Please see the image below, this is where you can locate the fuses.
...

My media is not circulating as good as what it was in the outer chamber of my Nexus.

You will need to check to see if your Airpump is working as it should be. The airline holes may have become blocked with limescale. To rectify this you will need to drain down the outer section and check the airline for any blockages.

What is Nexus Automatic?

The Automatic is a separate system which can be fitted to Nexus filters, to enable automatic cleaning. By combining timers and automatic valves, Nexus can be converted and set to clean itself, as little or as often as required. It can be set to clean...

How do I set a Nexus Automatic to clean at a set time each day?

As its an analogue timer the cleaning frequency will be purely based on time so for example once every 24h, you can dictate the time by pressing manual clean at say 6pm and then it will automatically clean at 6pm the following day. On a twice a day clean...

Nexus Automatic does not close waste valve

To locate the issue you will need to:

Check the relay furthest on the right in the auto box -
Check the fuse - Does it light up during a cleaning cycle?

If the relay is working as it should, you will need to check the motor. If it’s ...

The inlet valve does not turn on my Nexus during a cleaning cycle.

Check if the inlet valve is being obstructed. Check if the yellow light is illuminated. If light is not illuminated after 3 minutes, initiate a manual clean to check operation. Check the wiring is correctly installed. Seek advice from a suitably ...

How do I identify the spare part I need for my Nexus?

To ascertain what spare part you need for your Nexus please press read more and then click the thumbnail to open the PDF document and visualise the correct parts there are links provided on the pdf in order to take you directly to the part. ...

I have a nexus 320 pump fed automatic. I want to change to gravity fed. What do I need to purchase to do this.

Nexus Filters are supplied ready for pump fed installations. To convert it to gravity fed, please refer to the manual. https://evolutionaqua.com...

Did you find what you were looking for?

Your question:

Your name:

get notification on email when the answer is ready

Your e-mail:

Replacement outlet foam for old Nexus

Nexus Eazy Cleaning Pipe

Replacement centre foam for old Nexus

CONTACT INFO

Subscribe Newsletter

Help

Support

Cookie Policy

Replacement outlet foam for old Nexus

Nexus Eazy Cleaning Pipe

Replacement centre foam for old Nexus

Subscribe Newsletter

Help

Support